:
Maximum 200°C/min
*Separate Electric furnace and other system like Electronic scale
-Because Electric furnace temperature is very high
so we need to protect other system.
instrument composition
-Electric furnace
Temperature range:
25°C~1500°C
Heat speed :
Maximum 200°C/min
*Nitrogen or Argon in Electric furnace
-Because the inhibition of oxidization of sample
Sulfur Dioxide(SO2)
The release of SO2 to the atmosphere is the primary cause of acid rain in the world.
Fossil fuel combustion at electric power-generating plants accounts for about70% of
the emissions.
Coal, Oil, and all other fossil fuels naturally
contain some sulfur.
Volcanic eruptions are another more localized natural source of SO2
SO2 + OH. HSO3.
HS
catalyst
이 방법은 ethanol을 480℃의 공기 하에서 silver catalyst를 이용하여, acetaldehyde를 생산해 내는 방법이다.
2) Wacker oxidation of ethylene
ethylene을 사용함으로써, 위에서 ethanol을 사용하는 방법에 비하여, 더욱 직접적인 방법으로 acetaldehyde를 생산해 내는 방법이다.
3) Hydration of acetaldehyde
mercury salts
oxide gas sensors
The reason we take Nox as target gas
1. NOx is harmful to human health in its own right.
2. NOx reaction produces tropospheric ozone.
3. NOx causes acid rain, smog, and destruction of forests.
- This problems become more serious due to the rapid increase of car.
Sensitivity
▪ Temperature
▪ Catalyst
▪ Large surface area
▪ Low carrier co
catalyst를 발견하는 것이다.
메탄올의 내성이 있는 산소 환원 촉매의 몇 개의 종류가 논문에 소개되었다. 포르피린(porphyrin)과 프탈로시아닌(phthalocyanine)같은 전이-금속 macrocycles with N-based 리간드(ligand)는 산소감소에 활동적이고, 메탄올 산화에 영향을 받지 않는다. 다른 접근은 Chevrel-type( 이것은 중앙 8
be performed in a Clean Station Work Area which is located under an exhaust fume hood.
[Figure 1] RCA cleaning
the RCA clean proceedure consists of the following steps
: Chemical Storage ⇒ Mix Organic Solution ⇒ Mix Ionic Solution ⇒ Mix HF Solution ⇒ Set-Up Bubbler Rinse ⇒ Organic Clean ⇒ Oxide Clean ⇒ Ionic Clean ⇒ Transporting Wafers ⇒Drying
(1)Place 0.75(∓0.001g) unknown sample in 250ml beaker
and add 100ml distilled water.
(2) Do Experiment in the same way with Experiment A.
(3) Calculate mass and percentage of Na2C2O4 in unknown oxalate. And Calculate ratio in the same way with Exp A.
Volumetric flow rate : 50000 ft3/min
Assumption :
Ideal gas, 1atm, Iso-thermal reactor, No pressure drop, irreversible reaction
Check the input gas when the concentration of VOCs is 1.2 wt%
② Pseudo - Assumption
Rate determining step = Surface reaction
Almost catalyst reaction is determined by surface reaction
VOCs multi system = Toluene pure system
Average mole
EO 의 용도 - MEG, EO 유도체, 소독 및 살균제,
전분 및 셀룰로오즈등
국내 생산량의 90% MEG 제조에 사용
최근 EO 유도체의 수요 증가
(높은 반응성, 저렴한 단가))
산업용 가스로서의 시장은 아직 미미하지만 관련 산업의 발달과 함께 그 수요량 도 점차 증가할 전망
국내 주요 4개 업
Oxide 제조 공정
1.1. 공정개념도
1.1.1. 공정개념도
ethylene glycol
그림 . EO 제조 공정개념도
1.1.2. 운전 조건
가. 온도 : 250 °C , 촉매 : 금속 은 , 압력 : 1-2 MPa
나.이론적 수율 = 6/7 (85.7%)
다. 산업적 조건에서의 수율 = 83~84%
위와 같은 부반응으로 온도가 높아지면 수득률이 떨어지